Designed for restoration of surfaces of the details having a cylindrical form, and also details of other forms, by a method of semi-automatic welding in the environment of carbon dioxide or mixes. Submerged arc welding is possible. The control system allows you to perform surfacing in automatic mode.
UVN-700-1 plant
Designed for automatic surfacing of a technological layer of metal on internal openings of rollers of the caster, a wire of continuous section in the environment of protective gases.
AUNP-002 plant
Designed for automatic surfacing of a technological layer of metal on an external surface of details of the LPTs-1700 rolling machine: couplings, cases of bearings (pillows), spindles by a wire of continuous section in the environment of protective gases, and also a flux-cored wire.
Surfacing plant UN-05
Designed for automatic surfacing of a technological layer of metal on the external surface of the shafts in the environment of protective gases.
RM-9-02 plant
Designed for automatic surfacing of the treadmill, the inner surface and the upper part of the flanges of crane wheels with flux-cored wire, in a protective gas environment and an open arc with flux-cored wire with a diameter of 2.4; 2.8; 3.2; 3.6 mm, wires of continuous section 1.6 mm.
Automatic machine for surfacing of side frames and oversprung beams
Designed for semi-automatic surfacing of a technological layer of metal in the environment of protective gases.
Surfacing of rolls of a rolling mill plant AC354-7000-2
Designed for automatic surfacing of a technological layer of metal on an external surface of details in the environment of protective gases.
Surfacing plant UZ-500-1000
The UZ-500-1000 welding machine is designed for automatic welding of ring and longitudinal seams by argon arc method (TIG). The design allows you to adjust the location of the burner in height and depth, as well as adjust the angle. Control of work of installation is carried out from the remote control panel. The installation is completed with the block of automatic cooling of the BAO-1M torch.
Pass through the entrance of the Institute of Superhard Materials by car. Please, use the tips on the map below. Our office is on the second floor of the building.
